From: Ramy Sisy (rsisyie@gmail.com)
Date: Thu Jul 26 2007 - 10:05:11 ART
Yes, it is right.
I believe that you enabled static mapping first then you removed it and
tried to enable Inverse ARP.
By default when you enable static mapping, Inverse ARP will be disabled.
So when you enable a static mapping and want to remove it, it is better to
shut and no shut the interface to let Inverse ARP work again instead of
restarting all routers.
--------------------------------------------------------
Thanks,
Ramy Sisy
CCIE#17321 (Security), CCSI#30417, CCNP, C|EH, C|HFI, ISS-CA, MCSE, MCT
CCIE Security Content Manager/
Technical Instructor
Network Learning Inc - A Cisco Sponsored Organization (SO) YES! We take
Cisco Learning credits!
rsisy@ccbootcamp.com
http://www.ccbootcamp.com (Cisco Training and Advanced Technology Rental
Racks)
Toll Free: 877-NLI-CCIE (877-654-2243)
Outside USA: +1-702-968-5100
FAX: +1-702-446-8012
--------------------------------------------------------
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Ajay
Prakash
Sent: Wednesday, July 25, 2007 9:09 PM
To: Cisco certification
Subject: Re: Problem with Frame relay Inverse Arp
hmmm.. I dont know but the problem resolved itself after a reload of the 4
routers...
Ajay
----- Original Message -----
From: Ajay Prakash
To: Cisco certification
Sent: Thursday, July 26, 2007 9:22 AM
Subject: Problem with Frame relay Inverse Arp
Hello,
I am trying to configure a frame relay full mesh with 4 routers
R2
R1 Frame Relay R3
R4
The task asks me not to use static mappings. So all i needed to do was to
enable frame relay encapsulation and inverse arp should have taken care of
the
rest. However when i check the frame relay mappings, R2 has a map to all 3
other routers which is good. The routers R1, R3 and R4 only have mappings to
R2. The other dynamic mappings are missing.
I have waited for quie some time and the dynamic mappings have not
appeared.
I have tried static mappings and they work fine telling me that the frame
relay pvc is alright.
Any suggestions??
Regards,
Ajay Prakash
This archive was generated by hypermail 2.1.4 : Sat Aug 18 2007 - 08:17:42 ART