From: Chamara Peris (dimsyboy@gmail.com)
Date: Sat Jul 14 2007 - 21:14:31 ART
Hi Con,
In this situation the device it connects to be in the same vlan?. Because I
don't have access to the provider end which is the other end connects to the
4esw.
On 7/15/07, Con Spathas <con@spathas.net> wrote:
>
> You can't add an IP address directly onto the HWIC port. You'll need to
> create a vlan on the router and assign an SVI to it with an IP address.
> Then
> you add the HWIC port as an access port into the VLAN and you should be
> rockin and rollin.
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Chamara Peris
> Sent: Saturday, 14 July 2007 23:16
> To: Cisco certification
> Subject: Confusion on HWIC-4ESW
>
> Hi Group,
>
> I am planning to add hwic-4esw to one of my routers. But I am not exactly
> sure how this interface can configure for IP address. Cisco site indicates
> it's a L2 switching ports. All I want is to increase my Ethernet ports on
> 1841 by one more (comes with two Fast ethernet ports). By using hwic-4esw
> can it be configured with all 4 ports with 1 ip address (which gives me
> the
> additional ip address I required) or can it be configured with ip address
> to
> each port?.
>
>
> Or any other module for 1841 to achieve this?.
>
> Thanks
> CP
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Aug 18 2007 - 08:17:41 ART