From: Narbik Kocharians (narbikk@gmail.com)
Date: Sun Jul 08 2007 - 12:34:56 ART
I would definitely choose the first option; because that way you are
advertising and NOT redistributing. But the best would be to get a
clarification from the proctor. I agree with what Antonio wrote.
On 7/8/07, Antonio Soares <amsoares@netcabo.pt> wrote:
>
> Im my opinion, both are correct but in this case i would prefer the 1st
> method. Maybe it would be better to check with the proctor if they have
> any
> preference.
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Ovidiu Neghina
> Sent: domingo, 8 de Julho de 2007 14:34
> To: Cisco certification
> Subject: wording in the lab // advertise in the OSPF domain
>
> Hi dear all,
> If the ospf section of a lab requests:
> advertise loopback 0 interfaces of R1 in the OSPF domain without using
> network command and R1 has 3 areas: 0,27,34 what would be correct :
>
> 1. just pick an area and use ip ospf 1 area x under the interface, for
> example:
>
> Int lo0
> ip ospf 1 area 0
>
> or
> 2. use redistribute connected
> router ospf 1
> redistribute connected route-map CONN->OSPF
>
> route-map CONN->OSPF permit 10
> match interface lo0
>
> Your opinion is greatly appreciated
>
> All the best
> Ovidiu
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Narbik Kocharians CCIE# 12410 (R&S, SP, Security) CCSI# 30832
This archive was generated by hypermail 2.1.4 : Sat Aug 18 2007 - 08:17:40 ART