From: hadek.el-ayachi@nsn.com
Date: Mon Jul 02 2007 - 09:54:19 ART
I don't understand.
In my point of view, use PQ for voice traffic only, then exclude voice
traffic fron ACL 101 102 103 and use a normal service policy without
hierarchical MQC like this:
service policy qos
class voip
priority 90 ! Because max-reservable you set is 90%
class client1
bwd 33
class client1
bwd 33
class client1
bwd 33
Also, note that in your configuration below, you applied the qos only to
voice traffic and no qos is garanted for class-default!
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
ext Joe Higgins
Sent: lundi 2 juillet 2007 11:50
To: ccielab@groupstudy.com
Subject: qos problem
I have the following scenerio that I need some help . I have a link on
a serial interface that passes voice and data traffic to three clients.
My qos requirement is to give strict priority to all voice traffic
regardless to which client it is destined. I then have to give each
client one third of
any bandwidth that is still available. The following is my proposed
configuration.
class-map match-all rtptraffic
match protocol rtp voice
class-map match-all client1
match access-group 101
class-map match-all client2
match access-group 102
class-map match-all client3
match access-group 103
policy-map othertraffic
class client1
bandwidth percent 33
class client2
bandwidth percent 33
class client3
bandwidth percent 33
policy-map voice
class rtptraffic
priority percent 100
service-policy othertraffic
interface serial 1/0
max-reserved-bandwidth 90
service-policy output voice
This archive was generated by hypermail 2.1.4 : Sat Aug 18 2007 - 08:17:39 ART