From: Jason Guy \(jguy\) (jguy@cisco.com)
Date: Thu Jun 21 2007 - 16:34:53 ART
I am applying an outbound route-map to an EBGP peer to set the MED. I
can look on my "BB3" router and it certainly comes in with the metric I
specified. However, when I do a show ip bgp neighbor x.x.x.x advertise
it does not show the metric. Does this change happen after the routes
are packaged up for the peer?
It will hard to verify this in the real lab if I cannot see what I am
actually sending.
Thanks,
Jason
7200_R5(config-router)#do bgp nei 20.12.1.254 adv
BGP table version is 18, local router ID is 10.1.5.5
Status codes: s suppressed, d damped, h history, * valid, > best, i -
internal,
r RIB-failure, S Stale
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*>i10.1.4.0/24 10.1.45.4 0 100 0 i
Total number of prefixes 2
router bgp 65145
no synchronization
bgp router-id 10.1.5.5
bgp log-neighbor-changes
bgp confederation identifier 100
neighbor 10.1.45.4 remote-as 65145
neighbor 20.12.1.254 remote-as 54
neighbor 20.12.1.254 route-map TO_BB3 out
no auto-summary
!
ip prefix-list MED seq 5 permit 10.1.4.0/24
!
route-map TO_BB3 permit 10
match ip address prefix-list MED
set metric 500
!
This archive was generated by hypermail 2.1.4 : Sun Jul 01 2007 - 17:24:50 ART