From: Julio Carrasco (julio.carrasco@ya.com)
Date: Wed Jun 20 2007 - 21:10:20 ART
You can change the encapsulation from Frame-relay to ppp the frame-relay
again, to clear the mappings.
Regards.
----- Original Message -----
From: "Henk Botha" <henkbotha@hotmail.com>
To: <ccielab@groupstudy.com>
Sent: Tuesday, June 19, 2007 12:31 AM
Subject: Frame-Relay inarp
> The only way I know how to clear Dynamic mappings from a router after I
> used the No Frame-relay inverse-arp command is to restart the router.
>
> Is there another way to clear the frame-relay inarp without reloading the
> router? This will save so much time.
>
> Normally I shutdown the interface before enable Frame-Relay encapsulation
> but the problem is if I work on a lab that is already partially setup the
> mappings have already been learned.
>
> Any help to save some time.
>
> Thanks
>
> Henk
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Jul 01 2007 - 17:24:50 ART