From: Lidia Pastukhova (lidavpast@yahoo.com)
Date: Sat Jun 16 2007 - 16:17:49 ART
Cisco certification <ccielab@groupstudy.com> PI[ET: Hi,
You have tried to post to a GroupStudy.com certification mailing list. Because
the server does not recognize you as a confirmed poster, you will be required
to authenticate that you are using a valid e-mail address and are not a
spammer. By confirming this e-mail you certify that you are not sending
Unsolicited Bulk Email (UBE).
PLEASE DO NOT SEND YOUR ORIGINAL MESSAGE AGAIN! BY CONFIRMING THIS EMAIL
YOUR ORIGINAL MESSAGE (WHICH IS NOW QUEUED IN THE SERVER) WILL BE POSTED.
By confirming this e-mail you also certify the following:
1. The message does NOT break Cisco's Non-Disclosure requirements.
2. The message is NOT designed to advertise a commercial product.
3. You understand all postings become property of GroupStudy.com
4. You have searched the archives prior to posting.
5. The message is NOT inflammatory.
6. The message is NOT a test message.
To confirm, simply reply to this message. No editing is necessary. Once
confirmed, you will be able to post without additional confirmations.
Welcome to GroupStudy.com!
First time posters to GroupStudy.com are required to agree to the GroupStudy terms and conditions.
Replying to this email, certifies you have read and agree to the GroupStudy posting guidelines and terms and conditions.
--- Original Message Follows ---
Date: Sat, 16 Jun 2007 23:13:56 +0400 (MSD)
From: Lidia Pastukhova
Subject: tunnel mode
To: ccielab@groupstudy.com
Hello!
I have a problem. I need the tunnel interface take both the ipv6 and ipv4 packets. What kind of
(conf-if)# tunnel mode ?
can I used?
Many thanks,
Lidavpast
---------------------------------
wY UVE S Yahoo!? iSPYTAJTE OBNOWLENNU@ I ULU^[ENNU@. Yahoo! pO^TU!
Yours sincerely,
Lidia Pastukhova
---------------------------------
wY UVE S Yahoo!? iSPYTAJTE OBNOWLENNU@ I ULU^[ENNU@. Yahoo! pO^TU!
This archive was generated by hypermail 2.1.4 : Sun Jul 01 2007 - 17:24:49 ART