From: Jason Guy \(jguy\) (jguy@cisco.com)
Date: Sat Jun 16 2007 - 16:10:07 ART
I found you can shut the main interface, remove the subint p2p, and then
you can add the p2mp subint of the same number. Then unshut the main
interface. I thought reloading was the only way to convert the subint
as well. Now to completely remove a subint from "sh ip int brie"
output, you need the kickstart. :)
Jason
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> Joseph Saad
> Sent: Saturday, June 16, 2007 12:27 PM
> To: Mike Kraus (mikraus); 'Raj Bansal'
> Cc: ccielab@groupstudy.com
> Subject: RE: dorking up serial subinterfaces
>
> You remove the subinterface with the "no" command and reboot the
router.
> No
> other way.
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> Mike
> Kraus (mikraus)
> Sent: Saturday, June 16, 2007 5:42 PM
> To: Raj Bansal
> Cc: ccielab@groupstudy.com
> Subject: RE: dorking up serial subinterfaces
>
> Reboot the router! I've never found any other way. Or, if they don't
> specify the subinterface number, you could just pick a different
> subinterface number.
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> Raj Bansal
> Sent: Saturday, June 16, 2007 8:28 AM
> To: ccielab@groupstudy.com
> Subject: dorking up serial subinterfaces
>
> Folks:
>
> How do you come out of making a serial subinterface error. If I
> configure a subinterface as point to point and now want to make it a
> multipoint, it won't let me do it. It either shows up as deleted but
> when I try to configure it again, it says not allowed. Perhaps,
> something to do with idbs. What's a foolproof way of coming out of
> situations like these?
>
> Thanks.
>
> Raj
>
>
>
> ---------------------------------
> TV dinner still cooling?
> Check out "Tonight's Picks" on Yahoo! TV.
>
>
This archive was generated by hypermail 2.1.4 : Sun Jul 01 2007 - 17:24:49 ART