From: Narbik Kocharians (narbikk@gmail.com)
Date: Sat Jun 09 2007 - 13:26:34 ART
That would be a good typing test, its sure improve your typing.
On 6/9/07, Brian Dennis <bdennis@internetworkexpert.com> wrote:
>
> If you have a value of 5 seconds you'll need to round it up to 1 minute
> for
> the absolute-timeout command. Also it'll generate a warning message by
> default before it logs you out.
>
> --
>
> Brian Dennis, CCIE4 #2210 (R&S/ISP-Dial/Security/SP)
> bdennis@internetworkexpert.com
>
> Internetwork Expert, Inc.
> http://www.InternetworkExpert.com
> Toll Free: 877-224-8987
> Direct: 775-745-6404 (Outside the US and Canada)
>
>
>
>
> On 6/9/07 7:35 AM, "Darby Weaver" <darbyweaver@yahoo.com> wrote:
>
> > Imagine if you had to troubleshoot this one and it was
> > set to say 5 seconds?
> >
> > Interesting.
> > --- Brian Dennis <bdennis@internetworkexpert.com>
> > wrote:
> >
> >> Victor,
> >> That command is used to determine how long a TCP
> >> session will wait to reach
> >> the established state. The question was in regards
> >> to how to close a telnet
> >> session using an absolute timeout. The command is
> >> "absolute-timeout
> >> <seconds>" under the line configuration.
> >>
> >> HTH,
> >>
> >> Brian Dennis, CCIE4 #2210 (R&S/ISP-Dial/Security/SP)
> >> bdennis@internetworkexpert.com
> >>
> >> Internetwork Expert, Inc.
> >> http://www.InternetworkExpert.com
> >> Toll Free: 877-224-8987
> >> Direct: 775-745-6404 (Outside the US and Canada)
> >>
> >>
> >>
> >>
> >> On 6/8/07 4:46 PM, "Victor Cappuccio"
> >> <victor@ccbootcamp.com> wrote:
> >>
> >>> Hi,
> >>>
> >>> R1(config)#ip tcp synwait-time ?
> >>> <5-300> Wait time
> >>>
> >>>
> >>> Just put 5
> >>>
> >>>
> >>> thanks,
> >>> Victor Cappuccio.-
> >>> - CCSI# 31452
> >>>
> >>> Network Learning Inc - A Cisco Sponsored
> >> Organization (SO) YES! We take
> >>> Cisco Learning credits!
> >>> victor@ccbootcamp.com
> >>> http://www.ccbootcamp.com (Cisco Training and
> >> Rental Racks)
> >>> http://www.ccbootcamp.com/groupstudy.html
> >> (groupstudy member discounts!)
> >>> Voice: 702-968-5100
> >>> FAX: 702-446-8012
> >>>
> >>>
> >>>
> >>> -----Original Message-----
> >>> From: nobody@groupstudy.com on behalf of Adham Ali
> >>> Sent: Fri 6/8/2007 16:45
> >>> To: ccielab@groupstudy.com
> >>> Subject: Telnet Absolute Timeout!
> >>>
> >>> Dear All,
> >>>
> >>> Does anybody know how can i make a telnet
> >> session to a router be closed
> >>> automatically after some seconds (Not minutes) and
> >> the session closure should
> >>> be done evenif the session isn't idle?!!!
> >>>
> >>>
> >>> Waiting for relies!!
> >>>
> >>> Regards,
> >>> Adham.
> >>>
> >>>
> >>> ---------------------------------
> >>> No need to miss a message. Get email on-the-go
> >>> with Yahoo! Mail for Mobile. Get started.
> >>>
> >>>
> >>
> > _______________________________________________________________________
> >>> Subscription information may be found at:
> >>> http://www.groupstudy.com/list/CCIELab.html
> >>>
> >>>
> >>
> > _______________________________________________________________________
> >>> Subscription information may be found at:
> >>> http://www.groupstudy.com/list/CCIELab.html
> >>
> >>
> > _______________________________________________________________________
> >> Subscription information may be found at:
> >> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Narbik Kocharians CCIE# 12410 (R&S, SP, Security) CCSI# 30832
This archive was generated by hypermail 2.1.4 : Sun Jul 01 2007 - 17:24:48 ART