From: mihai (mihai@ngnpath.com)
Date: Wed May 30 2007 - 00:09:25 ART
Hi all,
Not sure what's going on ...
Here is what I have:
R5 --Eth--R3--Serial with clock rate 64k--R6
IP connectivity ok and ping from R5 to R6 ~ 6x ms
Start rtr on R5 to bring the serial between R3 and R6 to 100% usage.
Ping from R5 to R6 ~ 800 ms
I would like to test priority command with MQC for ping traffic (icmp)
My expectation is to get RTT around 6x ms with priority command in place.
This is not happening ... and I can't figure out what I'm doing wrong.
MQC related config:
class-map match-all t1
match access-group 100
!
policy-map p-t1
class t1
priority 16
access-list 100 permit icmp any any echo
access-list 100 permit icmp any any echo-reply
Service policy output p-t1 on R5,R3 and R6.
Any idea what's wrong with this test of mine?
Thx.
Mihai
This archive was generated by hypermail 2.1.4 : Fri Jun 01 2007 - 06:55:22 ART