From: Adel Abouchaev (adel@netmasterclass.net)
Date: Sun May 20 2007 - 20:21:37 ART
Is there a FR switch somewhere? Tell a bit more about the whole thing. Are
both routers DTE? No clocking?
Adel
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of To
Be CCIE
Sent: Sunday, May 20, 2007 1:18 PM
To: Cisco certification
Subject: frame-relay lmi-type
Guys,
I have the following setting for frame-relay and the link is not coming up.
Is there anything that I'm doing wrong here. Thanks in advance for any
input.
R1#
interface Serial0/0/0
ip address 155.32.12.1 255.255.255.0
encapsulation frame-relay IETF
frame-relay map ip 155.32.12.2 102 broadcast
no frame-relay inverse-arp
frame-relay lmi-type ansi
R1(config)#do ping 155.32.12.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 155.32.12.2, timeout is 2 seconds:
U.U.U
R2#
interface Serial0/0/0
ip address 155.32.12.2 255.255.255.0
encapsulation frame-relay IETF
frame-relay map ip 155.32.12.1 201 broadcast
no frame-relay inverse-arp
frame-relay lmi-type ansi
end
This archive was generated by hypermail 2.1.4 : Fri Jun 01 2007 - 06:55:21 ART