From: Josh (shmokin@gmail.com)
Date: Wed May 16 2007 - 19:54:55 ART
Hello Kim,
Try removing the passive-interface default command and see if it works.
On 5/14/07, Kim <support@isolvesystems.com> wrote:
>
> These devices are running in RIP domain. R4 has default-info originate to
> originate default to SW2 only, but this is not working.
> SW2(VL48)----(E0/1)R4(E0/0)-----(E0/0)R5
>
> The default is not showing up in SW2, nor R5.
>
> Rack1R4(config-if)#do sh run | be router
> router rip
> version 2
> passive-interface default
> no passive-interface Ethernet0/0
> no passive-interface Ethernet0/1
> network 156.1.0.0
> default-information originate route-map DEFAULT_ROUTE
> distance 60
> no auto-summary
>
>
> route-map DEFAULT_ROUTE permit 10
> match interface Ethernet0/1
>
> I asked this question few weeks ago. Someone said I had to use ip
> access-list. What address should I be matching on?
>
> Thanks.
> Kim
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Jun 01 2007 - 06:55:21 ART