default-information originate for RIP not working

From: Kim (support@isolvesystems.com)
Date: Mon May 14 2007 - 17:49:13 ART

• Next message: John Gibson: "Re: SRR, shared mode still performs shaping ?"
• Previous message: Muhammad Nasim: "Re: CCIE R/S *******Got my number********"
• Next in thread: Josh: "Re: default-information originate for RIP not working"
• Maybe reply: Josh: "Re: default-information originate for RIP not working"
• Maybe reply: Cagri Yucel: "Re: default-information originate for RIP not working"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

These devices are running in RIP domain. R4 has default-info originate to
originate default to SW2 only, but this is not working.
SW2(VL48)----(E0/1)R4(E0/0)-----(E0/0)R5

The default is not showing up in SW2, nor R5.

Rack1R4(config-if)#do sh run | be router
router rip
 version 2
 passive-interface default
 no passive-interface Ethernet0/0
 no passive-interface Ethernet0/1
 network 156.1.0.0
 default-information originate route-map DEFAULT_ROUTE
 distance 60
 no auto-summary

route-map DEFAULT_ROUTE permit 10
 match interface Ethernet0/1

I asked this question few weeks ago. Someone said I had to use ip
access-list. What address should I be matching on?

Thanks.
Kim

• Next message: John Gibson: "Re: SRR, shared mode still performs shaping ?"
• Previous message: Muhammad Nasim: "Re: CCIE R/S *******Got my number********"
• Next in thread: Josh: "Re: default-information originate for RIP not working"
• Maybe reply: Josh: "Re: default-information originate for RIP not working"
• Maybe reply: Cagri Yucel: "Re: default-information originate for RIP not working"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Jun 01 2007 - 06:55:21 ART