From: Mounir Mohamed (mounir.mohamed@gmail.com)
Date: Mon May 14 2007 - 14:55:25 ART
Dear Mohamed,
Rate-limit is simply one and should be used under the sub-interface for each
VLAN.
Best Regards,
Mounir Mohamed
On 5/14/07, mohammed shoeb ahmed <mdshoeb@gmail.com> wrote:
>
> Dear all,
>
> I have R2 fa0/0 Connecting switch 1, I created two interfaces on R2
> fa0/0.10
> for vlan 10 and Fa0/0.20 for vlan 20 with dot1q encapsultaion. I need to
> police incoming traffic from both Vlans to 5 Mbps. I see many solutions to
> this scenario but not able to decide which be best.
>
> see my solutions below
>
> # config t
> (Config)# int fa0/0
> (Config-if)# Rate-limit input 500000 8000 8000 conform-action transmit
> exceed-action drop
>
> Or
>
> I can acheive using MQC as well.
>
> What will be the best option should I apply on physical interface or
> should
> I apply on sub-interfaces.
>
> Your kind help will be appreciated,
>
> --
> Best Regards,
>
> Mohammed Shoeb Ahmed
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Best Reagrds, Mounir Mohamed
This archive was generated by hypermail 2.1.4 : Fri Jun 01 2007 - 06:55:20 ART