From: Andrew Larkins (andrew.larkins@BTGroup.co.za)
Date: Fri May 11 2007 - 11:02:17 ART
Try some prately steel putty and try join the screw back together...that
stuff is seriously strong and should be ok - just don't get any on the
back plate else nothing will work..
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Scott Morris
Sent: 11 May 2007 11:17 AM
To: ciscoroutergirl@gmail.com; ccielab@groupstudy.com
Subject: RE: Screwing a VWIC-2MFT-T1 too hard
That'd be a lesson in torque!
I haven't taken apart a 2801 to look at access on the inside, but I had
done
that before on a 3620... If you have a REALLY good set of needle nose
pliers, you can reach the end of the screw on the inside and twist it
just
enough to where it'll stick out and you can resume on the outside
perhaps.
I think you're beyond warranty at this point though, but you can try to
explain that one to TAC. :)
Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713,
JNCIE
#153, CISSP, et al.
CCSI/JNCI-M/JNCI-J
IPexpert VP - Curriculum Development
IPexpert Sr. Technical Instructor
smorris@ipexpert.com
http://www.ipexpert.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
ciscoroutergirl@gmail.com
Sent: Friday, May 11, 2007 3:20 AM
To: ccielab@groupstudy.com
Subject: Screwing a VWIC-2MFT-T1 too hard
I just got a brand new Cisco 2801 router and a VWIC-2MFT-T1. I tried to
screw the VWIC into the router, but I screwed it too hard. The screw
head
came off from the shaft (but I swear, I wasn't screwing that hard). Now
the
shaft is stuck inside the hole and I can't get it out. I tried to use
some
oil lube on it, but I could not get it to loosen up. A co-worker
suggested
that I try to drill it, but I am worried that the metal pieces will get
inside the router. Any other suggestions? Would this be covered under
warranty?
Router Girl
This archive was generated by hypermail 2.1.4 : Fri Jun 01 2007 - 06:55:20 ART