From: ciscoroutergirl@gmail.com
Date: Fri May 11 2007 - 04:20:19 ART
I just got a brand new Cisco 2801 router and a VWIC-2MFT-T1. I tried to
screw the VWIC into the router, but I screwed it too hard. The screw head
came off from the shaft (but I swear, I wasn't screwing that hard). Now the
shaft is stuck inside the hole and I can't get it out. I tried to use some
oil lube on it, but I could not get it to loosen up. A co-worker suggested
that I try to drill it, but I am worried that the metal pieces will get
inside the router. Any other suggestions? Would this be covered under
warranty?
Router Girl
This archive was generated by hypermail 2.1.4 : Fri Jun 01 2007 - 06:55:20 ART