From: Ivan (ivan@iip.net)
Date: Thu Apr 26 2007 - 05:34:55 ART
mvr vlan XX group XX - in dynamic mode must configured at both source/receiver
port.
http://www.cisco.com/en/US/products/hw/switches/ps646/products_configuration_guide_chapter09186a0080115956.html#xtocid19
see Note at "step 5"
On Thursday 26 April 2007 00:28, Riapolov, Bradley wrote:
> Bob,
>
> Thank you, as always. It is working now.
>
> -----Original Message-----
> From: Bob Sinclair [mailto:bob@bobsinclair.net]
> Sent: Wednesday, April 25, 2007 1:49 PM
> To: Riapolov, Bradley
> Cc: ccielab@groupstudy.com
> Subject: Re: MVR
>
> Riapolov, Bradley wrote:
> > I have looked around GS and DocCD, but cannot locate technical details on
> > how to verify whether MVR is operational:
> >
> > My source is on f0/3, receiver on f0/1, now what? When I ping 224.0.8.8
> > from the router hanging from f0/3 - I get no replies. Does anyone have a
> > good document on this or simply knows how this is supposed to work?
> > Thank you in advance.
> >
> > CAT2#sh mac ad mu
> > Vlan Mac Address Type Ports
> > ---- ----------- ---- -----
> > 40 0100.5e00.0808 IGMP Fa0/1, Fa0/3
> > CAT2#sh mvr int
> > Port Type Status Immediate Leave
> > ---- ---- ------- ---------------
> > Fa0/1 RECEIVER ACTIVE/UP DISABLED
> > Fa0/3 SOURCE ACTIVE/UP DISABLED
> >
> >
> > CAT2#sri mvr
> > mvr vlan 40
> > mvr
> > mvr mode dynamic
> > mvr group 224.0.8.8
>
> Bradley:
>
> Here is similar output from the SHOWiT engine for DOiT Lab 11 for a
> working configuration. Let me know what else you may need.
>
> ! CAT2#SHOW MVR interface
>
> Port Type Status Immediate Leave
>
> ---- ---- ------- ---------------
>
> Fa0/5 SOURCE ACTIVE/UP DISABLED
>
> Fa0/7 RECEIVER ACTIVE/UP DISABLED
>
>
> ! CAT2#sh run | inc mvr
>
> mvr vlan 40
>
> mvr
>
> mvr group 229.11.11.11
>
> mvr type source
>
> mvr type receiver
>
> mvr vlan 40 group 229.11.11.11 <<<<<<<< port facing receiver
This archive was generated by hypermail 2.1.4 : Tue May 01 2007 - 08:28:37 ART