From: Roman Rodichev (roman@iementor.com)
Date: Tue Apr 17 2007 - 09:34:20 ART
Are you sure you see this route in the bgp table on PE2? (show ip bgp vpnv4
vrf xxxx)
In this type of scenario you would need the "default-information originate"
command under "address-family ipv4 vrf xxxx" on PE1. This command is
required when you're bringing 0/0 route from a PE-CE IGP into BGP-IPV4-VRF.
On PE2 this default should be redistributed back into EIGRP without any
extra commands. Now, if you used OSPF as your PE-CE, you would need
"default-information originate" under OSPF-VRF on PE2.
Best Regards,
Roman Rodichev
5xCCIE #7927 (R&S, Security, Voice, Storage, Service Provider)
Instructor, Content Developer. ieMentor Corporation.
roman@iementor.com
http://www.iementor.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Mustafa Bayramov
Sent: Tuesday, April 17, 2007 11:24 AM
To: ccielab@groupstudy.com
Subject: CE-PE EIGRP default route not redistributed to VRF.
Folks,
Anyone faced with following issue with MPLS ?
EIGRP between CE1-PE1 and EIGRP between CE2-PE2.
CE1 advertise default route and PE1 redistribute all learned route to X VRF
to BGP , PE2 receive all prefix for X VRF and redistribute to EIGRP process.
PE2 see default route in BGP table and routing table for VRF X.
But I don't see default route in EIGRP topology and don't see it in debug
output of eigrp.
I was able to fix this issue by using different EIGRP AS number between
CE-PE1 and CE-PE2 in other word before that all AS number was same in MBGP
and EIGRP on both side and customer side.
Many thanks.
Mustafa Bayramov
Systems Engineer,
CCIE,CISSP
This archive was generated by hypermail 2.1.4 : Tue May 01 2007 - 08:28:36 ART