From: Edouard Zorrilla (ezorrilla@tsf.com.pe)
Date: Sat Apr 07 2007 - 09:11:37 ART
Ya it is on by default,
Regards
----- Original Message -----
From: <mariam.tatevik@yahoo.com>
To: <ccielab@groupstudy.com>
Sent: Saturday, April 07, 2007 3:58 AM
Subject: Re: Re: RE: IP split-horizon
> hi Laurence
>
> it is ON:
> http://www.cisco.com/en/US/tech/tk365/technologies_q_and_a_item09186a008012dac4.shtml#twelve
>
> which show command ? good question -
> show runn ;-)
> ok. at least you can always ckeck the default setting
>
>
> ================================================================
>
> Re: RE: IP split-horizon Huang Laurence Reply to sender to list
>
> From: "Huang Laurence" <huangyinxiao@gmail.com>
> To: mariam.tatevik@yahoo.com
> Cc: ccielab@groupstudy.com
> Subject: Re: RE: IP split-horizon
> Date: Sat, 7 Apr 2007 10:30:37 +1000
>
> Hi all,
>
> My topology like this:
>
> R1(point-to-point)----------(FR)--------------(point-to-point)R2
>
> There is no hub and spoken. And I enable the eigrp in this link. I know
> that in this situation, eigrp split horizon is disable by default. So I
> want
> to enable split horizon to prevent rooting loops. As far as I know, two
> commands can enable split horizon. One is "ip split-horizon"
> which is for rip, and the other is "ip split-horizon eigrp 10" which is
> for
> eigrp.
>
> In this situation, after I typed "ip split-horizon eigrp 10", which method
> or command can show that the command "ip split-horizon eigrp 10" take
> effect?
>
> Cheers,
>
> Laurence
>
> On 07/04/07, mariam.tatevik@yahoo.com <mariam.tatevik@yahoo.com> wrote:
>>
>> first of all, you have to check the ip subnet:
>> Are you using the same or not?
>> Because you can have the same ip address/subnet on
>> subinterfaces.
>>
>> For the same subnet (multipoint hub-spokes) I'd say you must
>> "reach" no ip split-horizon for both RIP & EIGRP
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue May 01 2007 - 08:28:35 ART