From: ian (iyux2000@gmail.com)
Date: Sat Apr 07 2007 - 08:32:03 ART
mariam.tatevik,How are you#!
If i remembered the correctly, the ip eigrp split-horizon has been disabled on Frame-relay interface by default, isn't it?
Refer to:
I did configure "ip split-horizon eigrp *" on my frame-relay interface, but i did "show run" and "show ip interface...", nothing indicates this command has been enabled. My IOS version is latest 12.4(12). Is it a IOS problem? Or by using some hidden eigrp command?
Because i do know there is a couple of hidden command relating to EIGRP.
======= 2007-04-07 18:59:16 What you've mentioned in your letter#:=======
>hi Laurence
>
>it is ON:
>http://www.cisco.com/en/US/tech/tk365/technologies_q_and_a_item09186a008012dac4.shtml#twelve
>
>which show command ? good question -
>show runn ;-)
>ok. at least you can always ckeck the default setting
>
>
>================================================================
>
>Re: RE: IP split-horizon Huang Laurence Reply to sender to list
>
>From: "Huang Laurence" <huangyinxiao@gmail.com>
>To: mariam.tatevik@yahoo.com
>Cc: ccielab@groupstudy.com
>Subject: Re: RE: IP split-horizon
>Date: Sat, 7 Apr 2007 10:30:37 +1000
>
>Hi all,
>
>My topology like this:
>
>R1(point-to-point)----------(FR)--------------(point-to-point)R2
>
>There is no hub and spoken. And I enable the eigrp in this link. I know
>that in this situation, eigrp split horizon is disable by default. So I want
>to enable split horizon to prevent rooting loops. As far as I know, two
>commands can enable split horizon. One is "ip split-horizon"
>which is for rip, and the other is "ip split-horizon eigrp 10" which is for
>eigrp.
>
>In this situation, after I typed "ip split-horizon eigrp 10", which method
>or command can show that the command "ip split-horizon eigrp 10" take
>effect?
>
>Cheers,
>
>Laurence
>
>On 07/04/07, mariam.tatevik@yahoo.com <mariam.tatevik@yahoo.com> wrote:
>>
>> first of all, you have to check the ip subnet:
>> Are you using the same or not?
>> Because you can have the same ip address/subnet on
>> subinterfaces.
>>
>> For the same subnet (multipoint hub-spokes) I'd say you must
>> "reach" no ip split-horizon for both RIP & EIGRP
>
>_______________________________________________________________________
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
= = = = = = = = = = = = = = = = = = = =
!!!!!!!!!!!!!!!!Have a nice day.
!!!!!!!!!!!!!!!!ian
!!!!!!!!!!!!!!!!iyux2000@gmail.com
!!!!!!!!!!!!!!!!!!!!2007-04-07
This archive was generated by hypermail 2.1.4 : Tue May 01 2007 - 08:28:35 ART