From: John Mistichelli (jmistichelli@yahoo.com)
Date: Mon Mar 19 2007 - 09:48:20 ART
Dishan,
Sounds like Control Plane is working but forwarding
plane is not.
That method of InterAS is tricky. Did you set up your
ASBRs using the redistribute connected method or did
you use next-hop-self? Can you post your configs? I
will be happy to take a look.
John
7536
--- Ben Zheng <bzheng8989@yahoo.com> wrote:
> Dishan
>
> When packet leaves from PE3, the source will be the
> ip address of it's WAN interface. This address shall
> be visable from PE4. Can you check it to see if this
> subnet is on PE4 routing table?
>
> Ben
>
>
> ----- Original Message ----
> From: Dishan Gamage <dishanlg@gmail.com>
> To: Cisco certification <ccielab@groupstudy.com>
> Sent: Saturday, March 17, 2007 11:29:15 PM
> Subject: SP question InterAS-VPN reacability
> issue!!!
>
>
> Hi Group
>
> I have the following setup configured.
>
>
>
CE2----PE3---------PE1-------ASBR1--------ASBR2-----PE-4-----CE6
>
>
> CE2---loopback 2.2.2.2
> CE6-- loopback 6.6.6.6
>
>
> CE2--PE3 routing protocol is eigrp 100
>
> PE4--CE6 is static
>
> VPNv4 is enabled between ASBR1 & 2 ( with bgp )
>
> I can see the loopback of CE2 on PE4, vrf but I
> cannot ping it...
>
> also on CE2 i can see the loopback of CE6, but
> cannot reach it
> either.........( each others routes are seen in both
> CE2 & CE6)
>
> when i do a trace from CE2 to CE6, trace stops after
> PE3 wan interface, also
> when i trace from CE6 to CE2 it stops after PE4
>
> but i have reachability from PE1 to PE4 & visa-versa
> via bgp ipv4 ,
>
>
> Pls comment, I ll be happy to post configs if
> needed............
>
> Tks in advance
> Dishan
>
>
>
>
>
>
> In cef it show correct...........
>
>
>
> From PE4 i am able to see the route
>
>
This archive was generated by hypermail 2.1.4 : Sun Apr 01 2007 - 06:35:51 ART