From: Kian Seng Goh (kianseng.goh@gmail.com)
Date: Mon Mar 19 2007 - 06:48:37 ART
huh?
how about in R1 (the hub)
as it only have 1 ethernet interface..how i put in different cost for
different neighbor ?
On 3/19/07, kenza@kenza.nl <Kenza@kenza.nl> wrote:
>
> configure ip ospf priority under the interface to influance the route as
> preffered.
>
> rgds,
> Kenza
>
> ----- Original Message -----
> From: "Kian Seng Goh" <kianseng.goh@gmail.com>
> To: <ccielab@groupstudy.com>
> Sent: Monday, March 19, 2007 10:00 AM
> Subject: OSPF next-hop manipulation!
>
>
> >i have 4 routers from different location running OSPF connected via a
> > metroEthernet network...
> > but due to the security policy... they would like to configure that all
> > traffic must route thru the HQ, instead of going from site to site
> > directly..
> >
> >
> > R1 R2 R3 R4
> > | | | |
> > --------------------------------
> >
> >
> > i would like to configure it to behave like a frame relay relay network
> > where all the site to site traffic must go thru R1
> >
> > R1
> > / \ \
> > / \ \
> > R2 R3 R4
> >
> >
> >
> > if its on a frame relay network.. by changing the OSPF network type to
> > multipoint will change the next hop address to the hub..
> > but in a broadcast network... does changing the ospf network type to
> > multipoint give me the same behavior ?
> >
> > or if anyone have any clue ?
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
> >
> >
>
>
>
> Disclaimer
> ************************************************************************
> Aan dit bericht kunnen geen rechten worden ontleend. Dit bericht is
> uitsluitend bestemd voor de geadresseerde. Als u dit bericht per abuis
> hebt ontvangen, wordt u verzocht het te vernietigen en de afzender te
> informeren. Wij adviseren u om bij twijfel over de juistheid of de
> volledigheid van de mail contact met afzender op te nemen.
>
> This message shall not constitute any rights or obligations.
> This message is intended solely for the addressee.
> If you have received this message in error, please delete it and
> notify the sender immediately. When in doubt whether this message
> is correct or complete, please contact the sender.
> ************************************************************************
This archive was generated by hypermail 2.1.4 : Sun Apr 01 2007 - 06:35:51 ART