From: Digital Yemeni (digital-yemeni@hotmail.com)
Date: Wed Mar 07 2007 - 01:37:08 ART
Can you put your interface config so we can look at it?!
Best Regards,
Digital
------------------------------------------------------------------------------------------------------------------
***********************************************************************************
*.* You'll NEVER succeed as a "CCIE" until you LOVE Cisco MORE than your
sleep! *.*
***********************************************************************************
I've not slept for the past 5 years and I'm expected to be busy for the next
57 years + The 5 CCIEs preparation adds on that a bit. Therefore, please be
concise on your email. Thank you!
>From: "yousef mohammed" <ccie2752536@gmail.com>
>Reply-To: "yousef mohammed" <ccie2752536@gmail.com>
>To: "ccielab groupstudy" <ccielab@groupstudy.com>
>Subject: Neighbor Command in OSPF
>Date: Wed, 7 Mar 2007 07:27:41 +0300
>
>Dear all
>
> I am trying to configure the OSPF over the Frame-relay. When
>ever
>i add the neighbor command under the OSPF, it gives me this error:
>OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint
>network.
>
>I didn't change the network type on the interface, it's the default which
>is Non-Broadcast.
>
>Now as a work a round solution, i remove the OSPF, then immediatly after
>creating the process, i adds the neighbor command ( before adding any
>network statment). the command is accepted now but i have to the same when
>ever i reload the router.
>
>
>I think this is a bug in the IOS, am i right, or did i mess somthing??????
>
>_______________________________________________________________________
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Apr 01 2007 - 06:35:50 ART