From: Mohamed T. Kondela (mtaib@sagia.gov.sa)
Date: Wed Feb 28 2007 - 09:04:49 ART
NAT was the quickest solution, but I think 3550 wont support NAT. I
remember that 6500 with right module can support NAT.
IF you don't want to add a 'Router Black Box' in between you can add a
MS ISA server between and do NAT/Route between these dittos. :)
Regards
Mohamed T. Kondela
Senior Network Engineer
IT Dept.
Fax: 4473037 x 303
mtaib@sagia.gov.sa
Saudi Arabian General Investment Authority
--------------------------------------------------------
This message contains confidential information and is intended only for the individual named. If you are not the named addressee you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. The sender therefore does not accept liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission. If verification is required please request a hard-copy version.
--------------------------------------------------------
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Gobind
Sent: Wednesday, February 28, 2007 2:38 PM
To: ccielab@groupstudy.com; bdennis@internetworkexpert.com; Brian
McGahan; Scott Morris
Subject: Interesting Question,Any answer?
Hi Guys,
Some one asked me this question,Its really interesting,Though should
post
it out here.here it is:-
There are two floors in a company which contains two Switches(each floor
has one--3550 Switch).
Floor one contains 20 hosts with IP address ranging frm
192.168.1.1-192.168.1.20
Floor Two also contains IP address with same IP address ranging from
192.168.1.1-192.168.1.20
Now he said that he wants the switch at Floor 1 be able to ping Floor
2(like from 192.168.1.1 at Floor 1 to 192.168.1.1 at Floor 2) and
exchange traffic and stuff,and the condition is that you dont have to
use
any router in between two switches.
So what could be the possible answer/config?
Cheers
Gobind
This archive was generated by hypermail 2.1.4 : Thu Mar 01 2007 - 07:38:48 ART