From: Ben (ccieben@cox.net)
Date: Mon Feb 19 2007 - 21:32:26 ART
Hi Mike,
See the last line of the show controllers output here:
Rack1R1#show ver | in IOS
Cisco IOS Software, 3600 Software (C3640-IK9O3S-M), Version 12.4(12),
RELEASE SOFTWARE (fc1)
Rack1R1#show control s1/1
M4T: show controller:
PAS unit 1, subunit 1, f/w version 1-45, rev ID 0x2800001, version 1
idb = 0x64270074, ds = 0x6427113C, ssb=0x642714F8
Clock mux=0x0, ucmd_ctrl=0x1C, port_status=0x7B
Serial config=0x8, line config=0x200
maxdgram=1608, bufpool=78Kb, 120 particles
DCD=up DSR=up DTR=up RTS=up CTS=up
line state: up
cable type : V.11 (X.21) DCE cable, received clockrate 128000
<snip>
If you have a different WIC, your mileage may vary...
HTH
Ben
Mike Ollington wrote:
> Hello,
>
> Does any one know how you determine the clock rate of a serial interface in
> 12.4 code? You used to able to use 'show controllers serial 0/0' and the
> received clock rate was near the top of the output. This doesn't seem to be
> the case any more.
>
> Is it hidden somewhere else?
>
> Regards,
> Mike
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Mar 01 2007 - 07:38:47 ART