From: Danshtr (danshtr@gmail.com)
Date: Sun Feb 04 2007 - 06:10:33 ART
There are some new protocols in draft, which will make SPT work little
like OSPF. A "routing protocol" will advertise mac addresses much like
OSPF advertises networks.
For example: Link State Protocol Over Mac Addresses
On 2/3/07, graham@cisco-engineer.com <graham@cisco-engineer.com> wrote:
> Hi group,
>
>
>
> I'm working on a question which asks to load balance between two switch
> endpoints 1 and 4
>
>
>
> The layout is
>
>
>
> ----------------- SW3------------
>
> SW1< >SW4
>
> ----------------SW2--------------
>
>
>
> Question in its self is not hard but the sting is, where you have a choice
> you must prefer source/destination ip Balancing?
>
>
>
> Now the load balance method that came to mind was a Layer 3 etherchannel and
> port-channel load balancing, but I can't see how that would fit in this
> scenario? Should I ignore the bit at the end which stipulates where you have
> a choice?
>
>
>
>
>
> Thanks
>
>
>
> Graham
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Best regards, Dan
This archive was generated by hypermail 2.1.4 : Thu Mar 01 2007 - 07:38:45 ART