From: Alexei Monastyrnyi (alexeim@orcsoftware.com)
Date: Sat Jan 27 2007 - 11:37:36 ART
I think full IP reachability refers mostly to IP/IGP diagram. Just to be
on the safe side, write down all the additional IPs you introduced
during the lab, like BGP loopbacks, Tunnel end-points, NAT translation
etc and ask proctor.
What you usually have is something like a requirement to make sure you
have full IP reachability after completing Switching/IGP sections. If
you have one, try not to break it in attempt to extend reachability to
those loopbacks etc introduced later. Ask if you are not sure, but
usually tasks are pretty clear about connectivity.
Bottom line is not to overanalyze simple 2 point tasks :-).
HTH
A.
Eli Kosharovsky wrote:
> Hi,
>
> With the full IP Reachibilty requerment ...
> Is it a must to achive it between all the address and the loopbacks in the
> topology ( even the one's added in later stages to test redistributin
> filtering ect.)
> Or only the initial addresses which apper at the diagrams. I get confused
> with it in in all my mock labs, wanted to get an answer to it for once :)
>
> Thanks in advance,
> Eli
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Feb 08 2007 - 23:46:57 ART