From: Bob Sinclair (bob@bobsinclair.net)
Date: Fri Jan 05 2007 - 13:18:22 ART
Static and dynamic mapping are your two options for mapping layer 3 to layer
2 addresses on Frame-Relay. It seems to me you have turned off dynamic
mapping for each of your DLCIs and have not provided static maps. So I
would expect that you would get no output from "sh frame map", for example.
If you want to disable dynamic mapping via inverse arp, then you will need
to replace it with static maps. I do not know your topology, but something
like the following:
Frame map ip 156.1.0.2 712 broadcast
Frame map ip 156.1.0.3 713 broadcast
Etc
In other words, map the far side IP to the near side DLCI.
Hope that helps. For more on Frame Relay you might check out the Class on
Demand on Frame-Relay that we offer at www.netmasterclass.net.
Bob Sinclair
CCIE 10427 CCSI 30427
www.netmasterclass.net
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
deji500@hotmail.com
Sent: Thursday, January 04, 2007 7:54 PM
To: ccielab@groupstudy.com
Subject: FRAME-RELAY INVERSE-ARP
HI,
Please i need your help. Why is it that sometimes, the frame-relay inverse
arp does not help in resolving layer 3 to layer 2 connectivity?
For example, i use the following interface commands in anticipation that the
DLCI that is not used with the no frame-relay inverse-arp ip command will
resolve to layer 3:
interface Serial0/0
ip address 156.1.0.1 255.255.255.0
encapsulation frame-relay
no frame-relay inverse-arp IP 711
no frame-relay inverse-arp IP 712
no frame-relay inverse-arp IP 714
no frame-relay inverse-arp IP 715
no frame-relay inverse-arp IP 718
no frame-relay inverse-arp IP 719
frame-relay lmi-type cisco
Thanks for your help
This archive was generated by hypermail 2.1.4 : Thu Feb 08 2007 - 23:46:55 ART