From: Brian McGahan (bmcgahan@internetworkexpert.com)
Date: Fri Dec 22 2006 - 15:23:32 ART
Router#show snmp mib ifmib ifindex
%SNMP agent not enabled
Router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#snmp-server enable traps
% Cannot enable both sham-link state-change interface traps.
% New sham link interface trap not enabled.
*Nov 21 19:05:12.751: %IP_SNMP-3-SOCKET: can't open UDP socket
*Nov 21 19:05:12.751: Unable to open socket on port 161
Router(config)#end
Router#
*Nov 21 19:05:16.403: %SYS-5-CONFIG_I: Configured from console by
console
Router#show snmp mib ifmib ifindex
Ethernet0/0: Ifindex = 1
Null0: Ifindex = 4
Serial0/0: Ifindex = 2
Ethernet0/1: Ifindex = 3
HTH,
Brian McGahan, CCIE #8593 (R&S/SP)
bmcgahan@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987 x 705
Outside US: 775-826-4344 x 705
24/7 Support: http://forum.internetworkexpert.com
Live Chat: http://www.internetworkexpert.com/chat/
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> Scott Thornton
> Sent: Friday, December 22, 2006 10:44 AM
> To: Cisco certification
> Subject: ifIndex
>
> Does anyone know what the show command is for a Cisco router to
translate
> the snmp ifindex number to the actual interface?
>
> Thanks.
>
> --
> Scott C Thornton
>
> Notice: This e-mail (including attachments) is covered by the
Electronic
> Communications Privacy Act, 18 U.S.C. 2510-2521, is confidential and
may
> be
> legally privileged. If you are not the intended recipient, you are
hereby
> notified that any retention, dissemination, distribution, or copying
of
> this
> communication is strictly prohibited. Please reply to the sender that
you
> have received the message in error, then delete it. Thank you.
>
>
This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:38 ART