From: Bryan F (cciebfetzer@gmail.com)
Date: Sun Dec 17 2006 - 22:35:31 ART
Funny you mentioned this, check this thread:
http://forum.internetworkexpert.com/ubbthreads/showflat.php?Cat=3&Number=10791&page=0&view=collapsed&sb=5&o=&fpart=1
I'd love to know what magic is being performed to get this to come up
according to IE. I have configured my lab about as close as possible
to their rack setup, from a hardware and IOS standpoint and I can't
make it work.
One person comments that they were able to get it to come up with
12.2T based code, only my BB's are running 12.2T and I have no plans
on downgrading R1-R6 just to see if I can make this work.
BF
On 12/16/06, Keith Bizzell <mkbcoolman@gmail.com> wrote:
> I'm seeing something strange with the virtual link. I can get it to work, I
> just cant explain why. The is no Area 0 defined in the topology, and the
> lab requires you to build a virtual-link between R3 and R1. I build this
> out on using the loopback addresses, but it will not work until I assign the
> loopback of R3 to area 0. After the virtual link is establised, I can
> remove the loopback from Area 0, and everything still works fine. Why? I'm
> uncomfortable with this solution on a lab, since I don't think this
> configuration would work on a reboot.
>
> Thanks,
> Keith
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:38 ART