From: yousef mohammed (ccie2752536@gmail.com)
Date: Sun Dec 17 2006 - 03:20:14 ART
Try to ping the group. this will initiate the traffic. then you will see a
change in the output of show ip mroute.
On 12/14/06, Liu_Liao <liu_liao@yahoo.com.tw> wrote:
>
> Hi All,
> I apply the rate-limt of multicast but I can see anything on my router
>
>
> interface FastEthernet0/0
> ip address 150.100.2.5 255.255.255.0
> ip pim sparse-mode
> ip multicast rate-limit out group-list 10 100
> ip igmp join-group 239.255.8.8
> duplex auto
> speed auto
> !
> access-list 9 deny 239.255.0.0
> access-list 9 permit any
> access-list 10 permit 239.255.8.8
>
>
> tp#sh ip mrou
> IP Multicast Routing Table
> Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C -
> Connected,
> L - Local, P - Pruned, R - RP-bit set, F - Register flag,
> T - SPT-bit set, J - Join SPT, M - MSDP created entry,
> X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,
> U - URD, I - Received Source Specific Host Report
> Outgoing interface flags: H - Hardware switched
> Timers: Uptime/Expires
> Interface state: Interface, Next-Hop or VCD, State/Mode
>
> (*, 239.255.8.8), 00:03:52/00:00:00, RP 0.0.0.0, flags: DPL
> Incoming interface: Null, RPF nbr 0.0.0.0
> Outgoing interface list: Null
>
> (*, 224.0.1.40), 00:03:52/00:00:00, RP 0.0.0.0, flags: DCL
> Incoming interface: Null, RPF nbr 0.0.0.0
> Outgoing interface list:
> Serial0/0, Forward/Sparse, 00:03:52/00:02:28
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:38 ART