From: Jens Petter (jenseike@start.no)
Date: Sun Nov 26 2006 - 16:07:27 ART
You will only need the frame interface-dlci command here if you need to
do some kind of frame class config for only this dlci... Otherwhise your
static map commands will take presence...
Also, no arp frame-relay will not do anything for you. This command have
no function in the ios at all. There are not even anything called arp in
frame-
relay. You can debug this to see this...
If your goal is to stop inverse arp the command is no frame-relay invers-arp
For your problem, yes check the frame-switch. But also the other side of the
serial link..
Mvh
Jens Petter Eikeland
Mob 98247550
Hipercom AS
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Nisar, Munsar
Sent: 19. november 2006 23:01
To: mzuo@ixiacom.com; ccielab@groupstudy.com
Subject: Re: need help with Frame Relay PVC problem
First off, why do you think you need to have "frame interface-dlci" command
on a physical interface? Secondly, I would check frame relay switch to
ensure that it is configured correctly. Thx.
-----Original Message-----
From: nobody@groupstudy.com <nobody@groupstudy.com>
To: ccielab@groupstudy.com <ccielab@groupstudy.com>
Sent: Sun Nov 19 13:36:17 2006
Subject: need help with Frame Relay PVC problem
Hi Group,
I see the following on my router:
R4(config-if)#do sh fram pvc | in DLCI
DLCI = 401, DLCI USAGE = UNUSED, PVC STATUS = INACTIVE, INTERFACE =
Serial0/0
DLCI = 402, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE =
Serial0/0
DLCI = 403, DLCI USAGE = LOCAL, PVC STATUS = INACTIVE, INTERFACE =
Serial0/0
DLCI = 405, DLCI USAGE = UNUSED, PVC STATUS = ACTIVE, INTERFACE =
Serial0/0
DLCI = 413, DLCI USAGE = UNUSED, PVC STATUS = INACTIVE, INTERFACE =
Serial0/0
R4(config-if)#do sh run int s0/0
Building configuration...
Current configuration : 238 bytes
!
interface Serial0/0
ip address 154.1.0.4 255.255.255.0
encapsulation frame-relay
no arp frame-relay
frame-relay map ip 154.1.0.3 403
frame-relay map ip 154.1.0.5 403
frame-relay interface-dlci 403
no frame-relay inverse-arp
end
R4(config-if)#
Is there any way I can find out why PVC 403 is inactive?
Thanks a lot
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:48 ART