From: anthony.sequeira@thomson.com
Date: Thu Nov 23 2006 - 11:11:47 ART
Here was all I worried about as far as verifications.....
First - is EIGRP truly running on the interface:
R1#show ip eigrp interface
IP-EIGRP interfaces for process 55
Xmit Queue Mean Pacing Time Multicast
Pending
Interface Peers Un/Reliable SRTT Un/Reliable Flow Timer
Routes
Se0/0/1 0 0/0 0 0/1 0
0
Next - did I configure the bandwidth percentage correctly:
R1#show run int s0/0/1
Building configuration...
Current configuration : 162 bytes
!
interface Serial0/0/1
bandwidth 64000
ip address 10.10.10.1 255.255.255.0
ip bandwidth-percent eigrp 55 10
end
R1#
The rest I took on faith....perhaps we will see the "magic show" command
for this one from someone, but I could not find it.
Anthony J. Sequeira
#15626
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Kay D
Sent: Thursday, November 23, 2006 8:39 AM
To: CCIE GroupStudy
Subject: how to view Eigrp Bandwidth using show command
Hi ,
The question wants me to assign 11 mbps bandwidth on serial link .
I
assigned the bandwidth on serial lnterface to 110000 Kb (110 mb) .
I have set "ip band eigrp 55 10" so as to set 10 % of interface
bandwidth on serial link . Is there a way that i can see that assigned
using
a particular show command .
TIA ,
Kay D .
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:48 ART