From: Scott Morris (swm@emanon.com)
Date: Thu Nov 23 2006 - 12:05:25 ART
It's just up to you and doing math. (Windows Calculator?) None of the show
commands that I've seen reference the limitations of bandwidth. You can use
"show ip eigrp interface detail" for some extra stuff about authentiation
and unicast operations, but nothing about bandwidth limits.
What? There's magic in the lab? Well, yeah, I think it's all part of that
"leap of faith" that we sometimes have to do! :)
Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, JNCIE
#153, CISSP, et al.
CCSI/JNCI-M/JNCI-J
IPExpert VP - Curriculum Development
IPExpert Sr. Technical Instructor
smorris@ipexpert.com
http://www.ipexpert.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
anthony.sequeira@thomson.com
Sent: Thursday, November 23, 2006 9:12 AM
To: krsna83@gmail.com; ccielab@groupstudy.com
Subject: RE: how to view Eigrp Bandwidth using show command
Here was all I worried about as far as verifications.....
First - is EIGRP truly running on the interface:
R1#show ip eigrp interface
IP-EIGRP interfaces for process 55
Xmit Queue Mean Pacing Time Multicast
Pending
Interface Peers Un/Reliable SRTT Un/Reliable Flow Timer
Routes
Se0/0/1 0 0/0 0 0/1 0
0
Next - did I configure the bandwidth percentage correctly:
R1#show run int s0/0/1
Building configuration...
Current configuration : 162 bytes
!
interface Serial0/0/1
bandwidth 64000
ip address 10.10.10.1 255.255.255.0
ip bandwidth-percent eigrp 55 10
end
R1#
The rest I took on faith....perhaps we will see the "magic show" command for
this one from someone, but I could not find it.
Anthony J. Sequeira
#15626
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Kay
D
Sent: Thursday, November 23, 2006 8:39 AM
To: CCIE GroupStudy
Subject: how to view Eigrp Bandwidth using show command
Hi ,
The question wants me to assign 11 mbps bandwidth on serial link .
I
assigned the bandwidth on serial lnterface to 110000 Kb (110 mb) .
I have set "ip band eigrp 55 10" so as to set 10 % of interface
bandwidth on serial link . Is there a way that i can see that assigned using
a particular show command .
TIA ,
Kay D .
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:48 ART