From: Adam Frederick (AFrederick@homefederalbank.com)
Date: Wed Nov 15 2006 - 01:38:02 ART
Core-3750-1#sh int po1
Port-channel1 is up, line protocol is up (connected)
Hardware is EtherChannel, address is 0015.6326.1c19 (bia
0015.6326.1c19)
MTU 1500 bytes, BW 2000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Full-duplex, 1000Mb/s, link type is auto, media type is unknown
input flow-control is off, output flow-control is unsupported
Members in this channel: Gi1/0/25 Gi1/0/28
Yoshe;
Notice BW = 2000000 Kbit, also notice Members in this channel = Gi1/0/25
& 28 which shows I have two gigabit interfaces bundled together for a
combined bandwidth of 2Gbps or 2000000 Kbit.
Hope this helps.
Adam
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Yoshe Rionando
Sent: Tuesday, November 14, 2006 10:59 PM
To: ccielab@groupstudy.com
Subject: Etehrchannel
Hi Folks,
How to verify speed of etherchannel. For example if i configure 3 port
fastethernet to etherchannel, how can i verify that speed is 300 mbps?
Yoshe Rionando Y.
PT. Swadharma Duta Data
Network & System Engineering Dept.
Senior Network Engineer
phone : 62 21 8318881
fax : 62 21 8297293
mobile : 62 8159084895
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:47 ART