From: Alex De Gruiter (Alex.deGruiter@didata.com.au)
Date: Wed Nov 15 2006 - 01:28:43 ART
show int port-channel [x]
i.e.
# show interface port-channel 1
Port-channel1 is up, line protocol is up (connected)
Hardware is EtherChannel, address is 0015.2b94.46ed (bia
0015.2b94.46ed)
Description: Channel group connecting to switch 2
MTU 1500 bytes, BW 4000000 Kbit, DLY 10 usec,
<--------------------------
# show etherchannel 1 summary
Number of channel-groups in use: 4
Number of aggregators: 4
Group Port-channel Protocol Ports
------+-------------+-----------+---------------------------------------
--------
1 Po1(SU) LACP Gi1/45(P) Gi1/46(P) Gi1/47(P)
Gi1/48(P)
Check out the bandwidth - the bonded interfaces will display bandwidth
using the same manner as "regular" interfaces.
Regards,
Alex
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Yoshe Rionando
Sent: Wednesday, 15 November 2006 2:59 PM
To: ccielab@groupstudy.com
Subject: Etehrchannel
Hi Folks,
How to verify speed of etherchannel. For example if i configure 3 port
fastethernet to etherchannel, how can i verify that speed is 300 mbps?
Yoshe Rionando Y.
PT. Swadharma Duta Data
Network & System Engineering Dept.
Senior Network Engineer
phone : 62 21 8318881
fax : 62 21 8297293
mobile : 62 8159084895
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:47 ART