RE: "host" keyward

From: Lab Rat #109385382 (techlist01@gmail.com)
Date: Sun Nov 12 2006 - 04:30:12 ART

• Next message: Lab Rat #109385382: "IOS-to-IOS IPSec Tunnel Question"
• Previous message: Michael Zuo: ""host" keyward"
• Maybe in reply to: Michael Zuo: ""host" keyward"
• Next in thread: Michael Zuo: "RE: "host" keyward"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

If "host" is specified, then the dynamic access list creates a host source
entry in the ACL. Without that command, the ACL should permit from "any"...

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Michael Zuo
Sent: Saturday, November 11, 2006 11:26 PM
To: ccie >> Cisco certification
Subject: "host" keyward

Hi Group,

Anyone knows what the "host" keyword in "autocommand access-enable host"
is for?

The Doc CD says: If the optional host keyword is not specified, all hosts on
the entire network are allowed to set up a temporary access list entry.

Which I have a hard time deciphering what it actually means....

thanks

• Next message: Lab Rat #109385382: "IOS-to-IOS IPSec Tunnel Question"
• Previous message: Michael Zuo: ""host" keyward"
• Maybe in reply to: Michael Zuo: ""host" keyward"
• Next in thread: Michael Zuo: "RE: "host" keyward"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:46 ART