From: nisha rani (nisharani1@googlemail.com)
Date: Sun Oct 29 2006 - 19:22:24 ART
You use advertise-map command when you are using as-set or community as an
option. Let's say if you want to create an aggregate-address with as-set and
want to advertise it back to some of the same AS. you must remove the
specific AS number from the AS_set to prevent the aggregate from being
dropped by the bgp loop detection at receiving router.
On 29/10/06, Adhu Ajit <adhu_ajit@yahoo.com> wrote:
>
> Folks, in the BGP aggregate address command, I do understand how the
> attribute-map option works. However, I do not quite understand how the
> <advertise-map> option works. Does someone have a config that would explain
> it to me plain and clear ?
>
> Thanks in advance.
>
>
>
> ---------------------------------
> Everyone is raving about the all-new Yahoo! Mail.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Nov 01 2006 - 07:29:07 ART