From: Jung-I Lin (easyman.lin@gmail.com)
Date: Fri Oct 06 2006 - 12:04:35 ART
Hi, chris
It seem R3 is the Hub router and R1,R2 is the spoke router.
If R1&R2 is not allow to use static mapping to Hub router and allow only
Main interface.
Then the choice would be using "dynamic mapping" between R1-R3 & R2-R3, or
"PPPoFR".
The second requirement also tell you to use "static mapping" between spokes.
So I think you need to use "static-mapping" on spoke-router to have them
point to each other.
And enable "inverse-arp" on R3 only with DLCIs to R1&R2.
You should have 2 dynamic maps on R3.
On R1&R2 you should have 1 dynamic(to R3) and 1 static mapping(R1-R2).
On 10/6/06, chris <iannaconec@optonline.net> wrote:
>
> I am confused by the task mentioned here
> Configure frame relay between R1 R2 and R3
> Use only the main interfaces
> Do not configure Static mapping from R1 to R3 or R2 to R3 or vice versa
> configure static mappings between R1 and R2 through R3
> Ensure IP connectivity
> would using dlcis on all the routers work and disabling arp on the
> static mapping
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Thanks Best Regards,Jung-I Lin
This archive was generated by hypermail 2.1.4 : Wed Nov 01 2006 - 07:29:04 ART