From: Fabio Rodrigues (fleandror2@gmail.com)
Date: Sat Sep 30 2006 - 18:19:43 ART
In fact I'm using this configuration to test IPv6 connectivity. The IPv6
pings also doesn't works.
----- Original Message -----
From: "Ivan" <ivan@iip.net>
To: <ccielab@groupstudy.com>; "Fabio Rodrigues" <fleandror2@gmail.com>
Sent: Saturday, September 30, 2006 6:06 PM
Subject: Re: Bridge-group doesn't work in Catalyst (3550 or 3560)
>
> This called fallback-bridging. It work only with non-IP traffic.
>
> On Sunday 01 October 2006 00:54, Fabio Rodrigues wrote:
>> Hi All,
>>
>> does anyone have problems with bridge-group configuration in Catalyst
>> 3550
>> or 3560 ? In my lab doesn't work. Look:
>>
>> vlan 27 vlan 72
>> R1--------------SW--------------R2
>>
>> R1:
>> interface FastEthernet0/0
>> ip address 10.1.1.1 255.255.255.0
>>
>> R2:
>> interface FastEthernet0/0
>> ip address 10.1.1.2 255.255.255.0
>>
>> SW:
>> interface FastEthernet0/1
>> description CONNECTED TO R1
>> switchport access vlan 27
>> switchport mode access
>> !
>> interface FastEthernet0/2
>> description CONNECTED TO R2
>> switchport access vlan 72
>> switchport mode access
>> !
>> interface Vlan27
>> bridge-group 1
>> !
>> interface Vlan72
>> bridge-group 1
>> !
>> bridge 1 protocol vlan-bridge
>> !
>> ! The VLANs 27 and 72 exist in database.
>> ! The IP Routing is activated in this switch because it also works with
>> L3
>> routing.
>> ! ------------------------------------------------------------
>> !
>>
>>
>> R1 Console:
>> R1#ping 10.1.1.2
>>
>> Type escape sequence to abort.
>> Sending 5, 100-byte ICMP Echos to 10.1.1.2, timeout is 2 seconds:
>> .....
>> Success rate is 0 percent (0/5)
>> R1#
>>
>>
>> Does anyone knows what is happen ? Is this config wrong ?
>>
>>
>> Tks,
>>
>> Fabio.
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>
> --
> Ivan
This archive was generated by hypermail 2.1.4 : Sun Oct 01 2006 - 16:55:42 ART