From: Ivan (ivan@iip.net)
Date: Sat Sep 30 2006 - 18:06:15 ART
This called fallback-bridging. It work only with non-IP traffic.
On Sunday 01 October 2006 00:54, Fabio Rodrigues wrote:
> Hi All,
>
> does anyone have problems with bridge-group configuration in Catalyst 3550
> or 3560 ? In my lab doesn't work. Look:
>
> vlan 27 vlan 72
> R1--------------SW--------------R2
>
> R1:
> interface FastEthernet0/0
> ip address 10.1.1.1 255.255.255.0
>
> R2:
> interface FastEthernet0/0
> ip address 10.1.1.2 255.255.255.0
>
> SW:
> interface FastEthernet0/1
> description CONNECTED TO R1
> switchport access vlan 27
> switchport mode access
> !
> interface FastEthernet0/2
> description CONNECTED TO R2
> switchport access vlan 72
> switchport mode access
> !
> interface Vlan27
> bridge-group 1
> !
> interface Vlan72
> bridge-group 1
> !
> bridge 1 protocol vlan-bridge
> !
> ! The VLANs 27 and 72 exist in database.
> ! The IP Routing is activated in this switch because it also works with L3
> routing.
> ! ------------------------------------------------------------
> !
>
>
> R1 Console:
> R1#ping 10.1.1.2
>
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to 10.1.1.2, timeout is 2 seconds:
> .....
> Success rate is 0 percent (0/5)
> R1#
>
>
> Does anyone knows what is happen ? Is this config wrong ?
>
>
> Tks,
>
> Fabio.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
-- Ivan
This archive was generated by hypermail 2.1.4 : Sun Oct 01 2006 - 16:55:42 ART