From: msaeed@uaeu.ac.ae
Date: Thu Sep 28 2006 - 01:23:28 ART
It gave warning message and command has been entered, but still if I ping from R5, it goes to R1 and R1 can not use this NBMA mode capability tp forward the mcast to R4, here is the so/0 output from sh runn on R1 and debug output on R1.
Rack1R1#sh runn
Output omitted
!
interface Serial0/0
ip address 174.1.145.1 255.255.255.0
ip pim nbma-mode
ip pim sparse-dense-mode
encapsulation frame-relay
no ip route-cache
no ip split-horizon eigrp 1024
no ip mroute-cache
delay 1
frame-relay map ip 174.1.145.4 104 broadcast
frame-relay map ip 174.1.145.5 105 broadcast
no frame-relay inverse-arp
!
Debug output on R1 when R5 is trying to ping 224.4.4 at R4 via R1
Rack1R1#
*Mar 1 00:57:02.815: IP(0): s=174.1.145.5 (Serial0/0) d=224.4.4.4 id=97, prot=1, len=104(100), mroute olist null
Rack1R1#
*Mar 1 00:57:04.815: IP(0): s=174.1.145.5 (Serial0/0) d=224.4.4.4 id=98, prot=1, len=104(100), mroute olist null
Regards,
Mohammad Zahid Saeed
----- Original Message -----
From: Brian Dennis <bdennis@internetworkexpert.com>
Date: Wednesday, September 27, 2006 11:36 pm
Subject: RE: IP PIM NBMA Mode for int in sparse-dense-mode
> Are you saying the NBMA mode command wasn't accepted by the IOS or are
> you saying that it gave you a warning message when you applied to
> command?
>
> HTH,
>
> Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
> bdennis@internetworkexpert.com
>
> Internetwork Expert, Inc.
> http://www.InternetworkExpert.com
> Toll Free: 877-224-8987
> Direct: 775-745-6404 (Outside the US and Canada)
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On
> Behalf Of
> msaeed@uaeu.ac.ae
> Sent: Wednesday, September 27, 2006 8:01 PM
> To: ccielab@groupstudy.com
> Subject: IP PIM NBMA Mode for int in sparse-dense-mode
>
> IEWB Lab 8 Task 5.4 Solution says put ip pim nbma mode under
> serial0/0on R1 when serial 0/0 is in sparse-dense-mode, router
> does not accept
> this command for an interface when it is in Sprase-dense-mode? So,
> evenwhen I change it to sparse mode and gave that ip pim nbma mode
> command,it didn't work, has any one tried some other solution?
>
> Regards,
>
> Mohammad Zahid Saeed
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Oct 01 2006 - 16:55:41 ART