RE: Route Redistribution into ospf

From: Brian Dennis (bdennis@internetworkexpert.com)
Date: Sun Sep 24 2006 - 00:04:10 ART


This is normal behaviour. Redistribution between routing processes is
two steps:

1) Bring in the routes from the routing table for the protocol being
redistributed from.
 
*** In your case these will be the EIGRP routes in the table table. You
can see these by doing a "show ip route eigrp".

2) Bring in the connected interfaces that the protocol is enabled on.

*** These are the connected interfaces that are encompassed by the EIGRP
network statements.

When you redistributed connected "manually" with a route-map you broke
step two that the router did automatically for the EIGRP redistribution.
Your redistributed connected route-map needs to include the connected
routes that are being brought in through the EIGRP redistribution.

HTH,
 
Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
bdennis@internetworkexpert.com
 
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Direct: 775-745-6404 (Outside the US and Canada)

 

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Kian Seng Goh
Sent: Saturday, September 23, 2006 6:17 PM
To: ccielab@groupstudy.com
Subject: Route Redistribution into ospf

My config as below :-

router ospf 100
  redistribute connected metric 2 subnets route-map Connected2OSPF
  redistribute eigrp 10 metric 2 subnets tag 170

What i notice is...
my EIGRP route doesn't get redistributed...whenever i do a
redistribute connected...

when i removed the redistributed connected line.. it works fine...
is this the normal behavior ? or i'm only allow to use the
redistribute command only once ?



This archive was generated by hypermail 2.1.4 : Sun Oct 01 2006 - 16:55:41 ART