From: Ivan (ivan@iip.net)
Date: Sun Sep 10 2006 - 19:33:24 ART
lake#conf t
Enter configuration commands, one per line. End with CNTL/Z.
lake(config)#rtr 2
lake(config-rtr)#type ?
dhcp DHCP Operation
dlsw DLSW Operation
dns DNS Query Operation
echo Echo Operation
frame-relay Perform frame relay operation
ftp FTP Operation
http HTTP Operation
jitter Jitter Operation
pathEcho Path Discovered Echo Operation
pathJitter Path Discovered Jitter Operation
slm SLM Operation
tcpConnect TCP Connect Operation
udpEcho UDP Echo Operation
lake(config-rtr)#type tcpConnect dest-ipaddr 10.10.10.10 ?
dest-port Destination Port
lake(config-rtr)#type tcpConnect dest-ipaddr 10.10.10.10 dest-port 80 ?
control Enable or Disable Control packets
source-ipaddr Source Address
source-port Source Port
<cr>
lake(config-rtr)#rtr schedule 2 life 600 start-time now
> Frank schrieb:
>
>
>
> Oh, it's working, just took the wrong vlan without an ip address. So the
> error was
> generated.
>
> Maybe there are other ways to generate traffic?
>
> Also how to generate traffic from a specific port?
>
> Frank
>
> > Hi,
> >
> > how would it be possible to generate traffic from a specific vlan?
> >
> > I gave the vlan an ip address and then tried to telnet from there with
> > a /source-interface option.
> >
> > SW1# telnet 131.1.23.1 80 /source-interface vlan 22
> >
> > ^
> > % Invalid input detected at '^' marker.
> >
> > SW1#
> > But for some reasons, this does not work. Probably telnet is expecting
> > other vlan variables.
> >
> > I just want to test a policy i see if certain traffic is matching.
> >
> >
> > Frank
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
-- Ivan
This archive was generated by hypermail 2.1.4 : Sun Oct 01 2006 - 16:55:40 ART