From: Ivan (ivan@iip.net)
Date: Sat Sep 02 2006 - 11:42:29 ART
This command was integrated in IOS 12.2(28)SB
check thik link:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124tcr/tirp_r/rtebght2.htm#wp1111400
On Saturday 02 September 2006 17:46, 2nd CCIE wrote:
> Hi Folks ;
> I know this has been for discussion recently ..but im not able to reach
> the solution from the archive ..so here we go --------R2 -------|
> R1------| R4
> -----------R3------|
>
> R1,R2,R3 are on same AS 10 , R4 on AS 20
>
> R4 advertises the lo1 netw (10.1.1.1/24) to both R2 and R3 via ebgp
>
> R2 and R3 send the network to R1 via ibgp
>
> what i want to achieve is that R1 load balance the traffic to R4 across
> both R2 and R3
>
>
> I can see the network 10.1.1.1 on the bgp table twice , however on the
> routing table is shows only from R2 .
>
> I am using maximum paths 2 on R1 , but i do not have maximum-paths ibgp
> at all under the bgp process (version 12.2(27))
>
>
> any ideas ?
>
>
>
>
>
> ---------------------------------
> How low will we go? Check out Yahoo! Messengers low PC-to-Phone call
> rates.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
-- Ivan
This archive was generated by hypermail 2.1.4 : Sun Oct 01 2006 - 16:55:39 ART