From: Brian Dennis (bdennis@internetworkexpert.com)
Date: Fri Aug 18 2006 - 15:11:05 ART
Yes you should reload the router to remove the subinterface. Also you could just use a different subinterface number.
Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
bdennis@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Direct: 775-745-6404 (Outside the US and Canada)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Udo Konstantin
Sent: Friday, August 18, 2006 10:48 AM
To: ccielab@groupstudy.com
Subject: Frame-Relay Problem - cannot change link type
Hi ll,
while configure framel-relay I I had the following problem...
1. I cfg ser0/0 on Rack1R5 wrong as point-to-point Now I want to change to multipoint. Right now I get the following message _______________________________________
Rack1R5(config)#int serial 0/0.245 multipoint % Warning: cannot change link type Rack1R5(config-subif)#no int serial 0/0.245 multipoint Not all config may be removed and may reappear after reactivating the sub-interface Rack1R5(config)#no int serial 0/0.245 multipoint ========================================
also I tried more than one time to remove this interface
One more I saw the following
=====================================
Serial0/0 unassigned YES unset administratively
down down
Serial0/0.245 unassigned YES manual deleted
down
================================
what happens here ? is this a bug ? The only way to change this behaviour is to reload the router !!?!?!?!
Thanks..Udo
This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:57 ART