From: Guyler, Rik (rguyler@shp-dayton.org)
Date: Fri Aug 18 2006 - 15:09:01 ART
True, you cannot change a sub-interface from one type to another. Deleting
and recreating the way to go here.
Removing a sub-interface will not totally remove it until you reboot the
router so do that and let us know if it fixes your problem.
Rik
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Udo
Konstantin
Sent: Friday, August 18, 2006 1:48 PM
To: ccielab@groupstudy.com
Subject: Frame-Relay Problem - cannot change link type
Hi ll,
while configure framel-relay I I had the following problem...
1. I cfg ser0/0 on Rack1R5 wrong as point-to-point Now I want to change to
multipoint. Right now I get the following message
_______________________________________
Rack1R5(config)#int serial 0/0.245 multipoint % Warning: cannot change link
type Rack1R5(config-subif)#no int serial 0/0.245 multipoint Not all config
may be removed and may reappear after reactivating the sub-interface
Rack1R5(config)#no int serial 0/0.245 multipoint
========================================
also I tried more than one time to remove this interface
One more I saw the following
=====================================
Serial0/0 unassigned YES unset administratively
down down
Serial0/0.245 unassigned YES manual deleted
down
================================
what happens here ? is this a bug ? The only way to change this behaviour is
to reload the router !!?!?!?!
Thanks..Udo
This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:57 ART