From: Scott Morris (swm@emanon.com)
Date: Wed Aug 02 2006 - 16:56:07 ART
Only if you want to look at the statistics...
"You must have already enabled Protocol Discovery and used it to obtain
statistics about the protocols and applications that are used in your
network."
But for matching/classification purposes, that's not necessary.
Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, JNCIE
#153, CISSP, et al.
CCSI/JNCI-M/JNCI-J
IPExpert VP - Curriculum Development
IPExpert Sr. Technical Instructor
smorris@ipexpert.com
http://www.ipexpert.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
srdja blagojevic
Sent: Wednesday, August 02, 2006 2:27 PM
To: 'Guzman, Chris'; ccielab@groupstudy.com
Subject: RE: NBAR and MQC
Chris,
you have to enable ip nbar protocol-discovery in order to use NBAR in MQC.
Here is useful link:
http://www.cisco.com/en/US/products/ps6441/products_configuration_guide_chap
ter09186a008064fb52.html#wp1043332
HTH,
Srdja
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Guzman, Chris
Sent: Wednesday, August 02, 2006 19:16
To: ccielab@groupstudy.com
Subject: NBAR and MQC
Is it necessary to enable NBAR on the interface using the ip nbar
protocol-discovery command in order to use NBAR to as match criteria in a
class map for a MQC policy
class qos1
match protocol ftp
In other words, will the match criteria work If I don't NOT have ip nbar
protocol-discovery enabled on the interface.
This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:55 ART