From: Curt Gregg \(cugregg\) (cugregg@cisco.com)
Date: Thu Jun 29 2006 - 20:07:17 ART
When creating Frame-Relay static maps for example say R6 to BB3.
BB3 is has 6 PVCs 100, 101, 201, 301, 401 and 51.
You only want to use inverse-arp on DLCI 51 from R6 to BB3
So options are :
R6
No frame-relay inverse-arp ip 100, 101, 201 etc..
or can you use
frame-relay inverse-arp ip 51
no frame-relay inverse-arp
which one superseds?
Next:
when showing frame map I see all the DLCI with blank ip address
Serial0/0 (up): ip 0.0.0.0 dlci 51(0x33,0xC30), dynamic,
broadcast,, status defined, active
Serial0/0 (up): ip 0.0.0.0 dlci 100(0x33,0xC30), dynamic,
broadcast,, status defined, active
Serial0/0 (up): ip 0.0.0.0 dlci 101(0x33,0xC30), dynamic,
broadcast,, status defined, active
Serial0/0 (up): ip 0.0.0.0 dlci 201(0x33,0xC30), dynamic,
broadcast,, status defined, active
etc...
is there a way to resolve this with out rebooting the router.. A reboot
show the correct results:
Serial0/0 (up): ip 54.1.3.254 dlci 51(0x33,0xC30), dynamic,
broadcast,, status defined, active
I have tried to the configuration with the interface shutdown and had
the same results.
THX in ADV.
Curt
This archive was generated by hypermail 2.1.4 : Sat Jul 01 2006 - 07:57:34 ART