From: jatinder.p.singh@bt.com
Date: Mon Jun 12 2006 - 08:12:48 ART
Dear All,
Please remember enable IP CEF on all routers. I failed first time due to
this only I forget to enable IP CEF on router where I have put QOS.
Best Regards
J P Singh | CCIE:- 13620 | Specialist: Design, Development & Consultancy
Services | Solutions Engineering Group , BT Global Services | Tel:+44
(0)1732 475950 | Mob:+44 (0)7918 886985 | Fax:+44 (0)1732 452335 | BT
Meet Me: 0870 241 1409 Participants Pass code: 33976421 | E:
jatinder.p.singh@bt.com | www.bt.com/globalservices
British Telecommunications plc
Registered office: 81 Newgate Street London EC1A 7AJ
Registered in England no. 1800000.
This electronic message contains information from British
Telecommunications plc which may be privileged or confidential. The
information is intended to be for the use of the individual(s) or entity
named above. If you are not the intended recipient be aware that any
disclosure, copying, distribution or use of the contents of this
information is prohibited. If you have received this electronic message
in error, please notify us by telephone or email (to the numbers or
address above) immediately.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Godswill Oletu
Sent: 12 June 2006 11:27
To: Petr Lapukhov
Cc: Sami; ccielab@groupstudy.com
Subject: Re: IP CEF
Petr,
Yes, I normally do that too in my home lab. It does not hurt to turn it
ON on all routers. The purpose of my email is actually to address the
relationship between CEF and CAR.
Thanks.
Godswill Oletu
----- Original Message -----
From: Petr Lapukhov
To: Godswill Oletu
Cc: Sami ; ccielab@groupstudy.com
Sent: Monday, June 12, 2006 4:00 AM
Subject: Re: IP CEF
Thanks Godswill :)
I did'nt check DocCD before answering, so my memory failed me :)
Anyway, I still think that turning CEF on every router is not that bad
idea. As I remember from my lab it has been turned on, when I verified
my "show adjacencies"
Petr
2006/6/12, Godswill Oletu <oletu@inbox.lv>:
Petr,
>
> AFAIR, CEF is not mandatory for CAR,
>
Are you sure about that?
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/
fqos_c/fqcprt1/qcfcar.htm#wp1000872
The above link referenced and I quote in part:
"....CAR and DCAR can be configured on an interface or subinterface.
However, CAR and DCAR are not supported on the Fast EtherChannel,
tunnel, or
PRI interfaces, nor on any interface that does not support Cisco
Express
Forwarding (CEF).
CEF must be enabled on the interface before you configure CAR or
DCAR......."
HTH
Godswill Oletu
----- Original Message -----
From: "Petr Lapukhov" <petrsoft@gmail.com>
To: "Sami" < sy1977@gmail.com>
Cc: <ccielab@groupstudy.com>
Sent: Sunday, June 11, 2006 3:43 PM
Subject: Re: IP CEF
> Sami,
>
> it wont hurt to enable CEF anytime, if you are NOT explicitly told
> to disable it :) After all, they have at least 12.3 on every
router in
> the lab now :)
>
> AFAIR, CEF is not mandatory for CAR, but it is required for
class-based
> marking and NBAR, to mention a few. Some other CEF-dependant
things
> are related to load-balancing, and BGP policy accounting, for
example :)
>
> Remember the main point of real lab: you could do anything that is
> not restricted by the task conditions, as long as you get the
result.
>
> The biggest problem is to figure WHAT is the required result ;)
That is,
> you need to pay extremal attention to the wording, and ask for
clarification
> on every doubtful moment. Next step is to figure how you can
verify your
> solution, and the rest is simple :)
>
> Oh yes, and if you have more than one alternative, choose the most
simple
> one :)
> The simplest solution is probably always the best.
>
> HTH
> Petr
>
> 2006/6/11, Sami <sy1977@gmail.com>:
> >
> > Group,
> >
> > I am confused when to use IP CEF while doing rate limiting. Is
CEF
> > mandatory for CAR or not ?
> >
> > Thanks.
> >
> >
This archive was generated by hypermail 2.1.4 : Sat Jul 01 2006 - 07:57:32 ART